Forums The Workshop Friendly Feedback Reply To: Friendly Feedback

#6677

Hi Martin

The wiring shown for the digital clock in the manuals does not match the pins in the offered sketch nor the ones shown as picture in the manuals – that was a little pitfall =)

Manual:
const int SER = 7; // Shift Register Serial Data pin
const int CLK = 8; // Shift Register Clock pin
const int LAT = 9; // Shift Register Latch pin
const int OE = 10; // Shift Register Output Enable pin

Manual Picture:
SER = 3
CLK = 4
Lat = 5

Sketch:
//DIGITISER Stuff

const int OE = 9;
const int SER = 10;
const int CLK = 11;
const int LATCH = 12;

const int sw1 = A2;
const int sw2 = A1;
const int Pot = A0;

Regards

Jean-Luc